Nićetin, MilicaLončar, BiljanaFilipović, VladimirCvetković, BiljanaFilipović, JelenaKnežević, VioletaPezo, Lato2023-07-172023-07-172022-09-19http://oa.fins.uns.ac.rs/handle/123456789/300The highest value of dehydration efficiency index was obtained by using molasses as osmotic solution, at 20 C, after 2.5 hours of process, performed with agitation (5.59), and without agitation (5.27), which was also observed on the PCA biplot. Based upon the presented results, the process was more efficient when it was performed with agitation, due to the better homogenization of the applied osmotic solution. Concerning osmotic solution impact on rate and efficiency of dehydration process, sugar beet molasses proved to be a better choice. Additionally, the use of molasses as an osmotic agent is more reasonable from economic, environmental and energetic aspects. It can be concluded that the mass transfer rate was the most intensive in the first hour of the process, and after 2.5 hours showed a tendency of slowing down. Therefore, osmotic dehydration time of wild garlic can be limited to 2.5 hours, which could contribute to significant energy savings.The availability period of fresh wild garlic is very limited, only during the spring season. After harvest, the leaves quickly lose their sensory, nutritious and functional properties. The stability and availability of this valuable herb material can be extended by adequate drying technique. The aim was to evaluate the influence of used osmotic solution, process duration, temperature and mixing on the mass transfer rate and the efficiency of process on wild garlic. The paper describes a study of osmotic dehydration of wild garlic (Allium ursinum L.) in sugar beet molasses and aqueous solution of sodium chloride and sucrose, at three different temperatures (20, 35, and 50 0C), with and without manual stirring in every 15 minutes. For this purpose, rate of water loss-RWL, rate of solid gain - RSG, rate of weight reduction - RWR and dehydration efficiency index - EI, were determined after 1, 2.5, and 4 hours of dehydration. In order to follow the mass transfer during the process, three key process variables were measured: moisture content, change in weight and change in dry matter, in accordance with Official Methods of Analysis (AOAC). Based on the obtained parameters RWL, RSG, RWR and EI were calculated. Principal component analysis (PCA) was applied to separate the samples according to the process parameters and characterize the observed samples. Higher values of the observed parameters was achieved when the process was performed with agitation. Mass transfer was the most intensive at the beginning of the process, at temperature of 50 0C. RWL, RSG, RWR and EI decreased continuously from the first to the fourth hour, and after 2.5 hours showed a tendency to slow down. The highest value of EI was obtained by using molasses as osmotic solution, at 20 C, after 2.5 hours of process, performed with agitation (5.59), and without agitation (5.27), which was also observed on the PCA biplot. Mass transfer was the most intensive at the beginning of the process, decreased continuously from the first to the fourth hour, and after 2.5 hours showed a tendency to slow down. Therefore, processing time can be limited to 2.5 hours.enOsmotic dehydrationWild garlicEfficiency of dehydrationMass transfer rate,PCA analysisinfo:eu-repo/semantics/article